ther is any difference if we use 240 V A.C,50 Hz,1 Ph. in
place of 230 V A.C,50 Hz,1 Ph.
- 4 Answers
- 5462 Views
- I also Faced
- E-Mail Answers
Answer Posted / arulkumaran
YES, some difference.
example: tube light
if use 240v : * light full brightness
* life time low
if use 230v : * brightness little bit lower than 240v
* life time higher than 240v light.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the different types of hydro schemes?
What are the two major types of control system?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How to calculate fault level of 11 KV system
Mention how NPN and PNP transistor works?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
why does connected a indutor with mnsformeretering core of current transformer ?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
Define pole pitch?
What are motor generator sets and explain the different ways the motor generator set can be used ?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
What is the equivalent circuit of a transformer and its vector diagram?
what are the difference between PLC and embedded
The screw thread commonly used for transmission of motion is one of the following types of threads
