WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?
Answer Posted / eswari
GIS - Gas insulated substation
AIS - Air Inuslated Substation
GIS - high efficiency, requires less maintenance, less
space and less global warming when compared to AIS. but GIS
cost is two times higher than AIS.
Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
why there using acb enclosure in big buildings
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
Whether power factor should be high or low? Why?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
what are types of encoder
How dia computation perfomed in cold rolling mills .
What is the emf equation of a transformer?
how to select energy meter? have any calculation?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What is gross error?
is it possible to have dc motors on single chip
our industries ht line so power fluctation(once drop of power please rectify causes