what is the physical phenomenon because of which skin
effect occurs ??
- 6 Answers
- 9207 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / subrata
Skin effect is mainly cause by circulating eddy currents. Eddy currents effectively
oppose the original current that was flowing to the center of the conductor, thus pushing it to the outer surface of the conductor.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
How many types are using in 220kv/400 kv swith yard
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
where rlc series ckt used?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
how can i change the rotation of the AC single phase induction motor and show me by diagram
What is the settings of distance protection relay in 400 kv line
Purpose of providing neutral isolation panel for parallel operation of diesel generator
how desiel generate sart fail of eb?
When and where resistance earthing is used ? How to calculate the time constant for earth fault
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
How stabilizer works??
