Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body tell me about Hi-pot test, and why it is
necessary and its procedure of testing
- 6 Answers
- 9941 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheik
this test you can know well of your equipment
insulation strength and conductor strength
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is Faraday's law
what is the saturation point of crgo lamination.
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
what is there inside an inverter and how it works?
Define super node?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
What are dependent sources?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
What is the height of DA, DAL, DB, DC & DDE tower?
what is the effect of power factor of machines in starting current
If increased the frequency up to 1000 then what changes shows in voltage?
