why digital signals are preferred over analog in com?
- 7 Answers
- 20895 Views
- I also Faced
- E-Mail Answers
Answer Posted / preeti kumari(college of bio-m
1)almost all electronic devices use digital signals,because they remain accurate in shape and amplitude.2)transmission is at a higher rate and with a wider broadband width.3)it enables multi-directional transmission simultaneously.4)there is minimal electromagnetic interference in digital technology
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is handover?
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
Why is transistor called a current controlled device ?
Define what is a high-pass filter?
hi...i had completed B.E.in Electronics & Communication.i had applied Section Engineer in railway recruit ment 2012.I need previous year exam papers.
How to convert a binary number into bcd number directly and vice-versa, without converting it into any other number system?
will anyone pls tell me which is the best institue for oracle certification and approx fee for that in banglore....
for linear polarisation antenna how do u measure polarisation?
difference between transient & Steady state response?
What are the charge carriers in p-type and n-type semiconductors?
what is voltage drop?
In Telecom, While call set up what are the Masseges will flow from all network element to each other.
What are chebushev filters? Explain?
What is the output power of a BTS, in dbm &watts if trx=2+2+2... if trx=4+4+4..
What is meant by mcmurray inverter?
