Answer Posted / zerocool
ita type of inverse transducer not totally inverse
transducer itsa ctually an OUTPUT TRANSDUCER..
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What do you know about gail?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
Draw block digram for well head from well to shipping pump?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Explain the difference between mmwc and mmwg?
What is 3 selection available when configure the burnout protection for controller
detail of mass flow meter pricipal
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is 24vdc live and dry supply
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Identification of control valve parts.
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
What is instrumentation technologists and mechanics?
