why transformer rating in kva and motor rating in kw
- 11 Answers
- 14590 Views
- I also Faced
- E-Mail Answers
Answer Posted / gms
RATING is given in kw when we have any knowledge about the power factor of the load which is to be connected on the output side.
in case of the transformers we have no information about the power factor of the load so it is evident to define its ratings in terms of (VA)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
How to measure size of cable on a given load
what is the significance of cabability curve of alternator
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
What is the technical difference between On delay timer and a Star delta timer?
Define settling time.
what is v/f control in VFD?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
At full load wat is the motor p.f And at no load will is the motor p.f?
I WANT BHEL PREVIOUS QUESTION
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
What is the drawback of class b amplifier? How is this minimized?
