Answer Posted / prashanth
5% for plastering
7.5% for concrete
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
how u design STAGING for Superstructure in BRIDGE construction?
What is the worlds largest concrete dam?
What is Base Shear ?
What are the different theories of failure under static load?
Where will be the maximum bending moment in a TEE Beam?
What sizes of stones chips are used for foundation, column and floor casting. Please answer in detail.
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
HOW SOON CAN YOU TRAVEL DON TO ANY LOCATION POSTED U?
Please tell me any one, how many quantity concrete paver block fixing perday ( 8hours) per mason??
Minimum concrete cover in slabs, columns, beams, foundation and other st?
What are the ingredients of pre-stressed concrete?
what is the formula for Mass of cement grout (Dg)=???
Can we weld hot rolled steel ASTM A615 ? Please Give the detail answer please thanks alot
