Answer Posted / kiran@c&s electric ltd
earthing and grounding are the same, grounding terminology
is used in american standards whereas earthing is used in
electrical standards and earting is provided for human
safety and the chassis of the electrical equipment which
are intended as non current carrying parts is grounded
(earthed) to earth
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
what is the function of Moulded case circuit breaker, why it is called Moulded?
what is the breaking capacity and making capacity of circuit breaker and how
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
How to connect the chemical earthing and complete process tell me plz
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
what is the difference between linear choke and suction choke?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
how to setting voltage RTCC panel
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
