Answer Posted / sandaruwan
we use 3 ff
because 8 mod has 3 bit we can find number of ff like this
2^n 8 mod 2^3 3= number of ff
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Describe the purpose of knee point voltage for differential protection.
If we use heat sinkble rechem make HT jointing kit for XLPE HT (6KV)termination at HT side of transformenr, Is it required to fill the HT termination with Epoxy compoud?
What are the advantages of single phase bridge converter over single phase mid-point converter?
How will you determine what frequency the device has without using oscilloscope?
What is a schmitt trigger?
Explain what kind of negative feedback is present in a noninverting op-amp.
what is frame structher in SDH .
What is the difference between plc and dcs control system?
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
Impedence of a parallel resonant circuit at resonance is ?
What are the advantages of parallel optical interface?
plz give the question about interview to the post JR.Executive (ATC)
explain the principle of operation of successive approximation adc.
Tell me how many mosfet switches are there in dynamic ram?
how to determine AC frequency through hardware ?
