Why we called L-G fault as line to ground fault why ground?
suppose if a line falls on building roof then can we called
these fault as line to roof fault? please explain why
ground term is used here?
- 3 Answers
- 4902 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / ram
because building is on the ground,so ultimately it has to fall on ground.they both have same meaning.
| Is This Answer Correct ? | 1 Yes | 11 No |
Post New Answer View All Answers
what is the difference between electrical and electronic choke?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
Why collecting electrode of ESP to be earthed
how to select battery for 15 KVA UPS with formula
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is the percentage loss for aluminium wire for HT line more than 11KVa
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
how many joint can done in HT line and what is life of the joint
What is depreciation factor?
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
plz explain the auot-reclosing circuit in electrical engineeing
