Why one can experience electrical Shock due to Voltage or
Current?? or both voltage or current??
- 11 Answers
- 12017 Views
- I also Faced
- E-Mail Answers
Answer Posted / vignesh
Voltage and Current are depending with each other. Voltage
and Current will be defined based on the load resistance.
When the load(Human Body) has high resistance, there wont
be any current. Then you wont get any shock. Think ...you
are getting shock when you touch a coin cell your tonque.
But you wont get the shock, when you touch with your hand.
Because you have more resistance in your hand and less
resistance in your tonque
Conclusion:
SHOCK IS DUE TO THE RESISTANCE OF THE HUMAN BODY
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
explain the mode of metal iranafer in Co,welding
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
how we calculate the withstansing current capacity of wires&cables?
can i connect wavetrap in 2 different phase in EHV line?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
what is the advantages og idmt relay over magnetic relay??
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
Is it possible to connect a safety device in to parallel?
Any one can explaination about calibration with rotating sub standards?
What is the RME and explain the full form and what is the RME work?
what is the relative size of single and three phase?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
