Answer Posted / pradhyumn
Ideal Power factor is 1.
It is ratio of real power(measured in watts) flowing to the
load to apparent power(measured in VA). It ranges between 0
to 1.
P.F. is a measure of the degree to which a given load
matches to that of a pure resistance.
P.F.=1 if load is purely resistive.
P.F.=0 if load is inductive or capacitive or both.
For RL-circuit P.F. is between 0&1.(lagging)
For RC-circuit P.F. is between 0&1.(leading).
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Why star delta starter is preferred with induction motor?
Advantage of LT panel vs HT panel
what happen if the parallel generator phase angle shift by 1 degree in manual mode
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
how mass curve differs from hydrograph.
What is the lower limit of break-down voltage of converter transformer.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
What is zero of the system?
What is DC series motor?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
what is negative and zero impedance in 3 phase induction motor ??
