Answer Posted / maruthi
1.Body earthing
2.Neutral earthing
3.Winding Temperature
4.Over current protection
5.Over/Under voltage protection
6.Over/Under frequency protection
7.Earth fault protection
8.Reverse power protection
9.Loss of field protection
10.Bearing Temperature
11.Loss of Exciation
13.Neutral current maxium.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
what is different between relay and plc?
What is ramp signal?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
what work will do diffrential realay DG set
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
Explain Continuous and Discrete signals?
what is conductor copnstant of ab cable
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
What is capacitance?
How can I calculate ISF of current transformer?
How shall i select the value of capacitor or inductor in a system?