Answer Posted / devendra_kushwaha27
When an AC excitation signal is applied to the Primary Coil
(P), voltages are induced in the two Secondary Coils (S).
The MAGNETIC CORE inside the COIL WINDING ASSEMBLY provides
the magnetic flux path linking the Primary and secondary
Coils.Since the two voltages are of opposite polarity, the
Secondary Coils are connected series opposing in the
center, or Null Position. The output voltages are equal
and opposite in polarity and, therefore, the output voltage
is zero. The Null Position of an LVDT is extremely stable
and repeatable.
When the MAGNETIC CORE is displaced rom the Null
Position, an electromagnetic imbalance occurs. This
imbalance generates a differential AC output voltage
across the Secondary Coils which is linearly proportional
to the direction and magnitude of the displacement.
As shown in the figure, when the MAGNETIC CORE is moved
from the Null
Position, the induced voltage in the Secondary Coil, toward
which the Core is
moved, increases while the induced voltage in the opposite
Secondary Coil
decreases.
LVDTs possess the inherent ruggedness and durability of a
transformer and
truly provide infinite resolution in all types of
environments. As a result of the
superior reliability and accuracy of LVDTs, they are the
ideal choice for linear
motion control.
LVDT Principle of Operation Page 1 of 2
http://www.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
how to design orifice plate?what is the equation?
what is compensation? temprature & pressure
explain key exchanges in all security modes WPA,WPA2,TLS?
How many ohms are required for proper earthing?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
TEMPERATURE VARIATION FOR FREQUENTLY.
how can leve transmetter calibate in feild .and also put cv and flow plz .....
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Give 2 application of quartz crystal used for process parameter measurement.
Calibration procedure for Electro magnetic Flow meter
