is it possible to flow a current between nutral and earth
in a circuit? although nutral and earth having same
potential diffrence?
i=0/r=0A
if any body now any solid reason because i am getting a
triping problem in rcbo due to nutral and earth shorting???
- 2 Answers
- 3405 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If there is a loose connection in the neutral wire ,neutral
point gets shifted to the point of loose connection at the
incoming.Then there will be some voltage in the neutral wire
beyond it, resulting in flow of current when in contact with
the earth wire.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
In Power cable specification what is U0/U and Um.
How efficiency of thermal plant can be improved?
What is the dependency of stiffness on load angle??
Define maximum demand?
draw singleline diagram of star to delta and dol starters
which type of questions asking for solar companies?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What are the components of feedback control system?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
what is the isolation transformer. what is the isolator?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
