Which buffer solution is used for PH transmitter
calibration?
- 3 Answers
- 5900 Views
- I also Faced
- E-Mail Answers
Answer Posted / satyajit sahani
Hi,
For pH transmitter you can use buffer solution in betwen
your pH sensor range.But when you are going to calibration
use buffer solution 7.00(Neutral)then any solution from
either Acid side(4.01)or alkali side(10.0)
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is easiest way to read STL language in PLC?
give eg of how I/P is used in control loops
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
Is there any relation between Artificial Intelligence and Instrumentation?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
How to Calibrate Interface Level Troll in field
what is the calibration procedure for transweigh make weigh feeder?
kindly sent some demo question and answer
where cascade loop use ?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
State some of balance principle’ advantages?
What is PDS and PDMS ?
What is eddy current? Describe the operating principle of proximity probe.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
