Answer Posted / munesh natrrajan
When the Length of Bars available in the market is many
times smaller than the length required or when pieces of
bars are to be utilized,the bars are required to be lapped
that lapped length is called lap length.
Lap length will be as follows;
Tension - Ld or 30 x diameter of bar,whichever is greater.
Compression - Ld or 24 x diameter of bar,whichever is
greater.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the l/d ratio of cantilever beam?
HDPE pipe standard bends using for TSE irrigation? is it possible to use 30 degree?
sir, please send me the web address of chennai railway to know the online examresults of junior engineer[civil].
what is tension & compression of steel bending.
What do you understand by “preset” during the installation process of bridge bearings?
sir i want to know that in L & T construction can we do our 6 months training proggramme cum placement???????
What is meant by cad?
How many cement sand ballast in cc 1:4:8 40mm
What is the ratio of grades m5, m7.5, m10, m15, m20, m25, m30, m35, m40?
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
how can i calculate cement in brickwork
What type of tensile strength is handling by crank in beam? Thanks.
How to find beam R/F cutting length
What are new methods /technologies of pothole patching?
What is OSHA compliance?
