Is there’s power on the bus (if so, state whether on the
signal bus, or on a separate in the following:
a) HART
b) Profibus DP
c) Profibus PA
d) DeviceNet
e) Foundation Fieldbus
- 1 Answers
- 3495 Views
- EIT, I also Faced
- E-Mail Answers
Answer Posted / sanjay daxini
Foundation Fieldbus
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
can you provide me full detail about instrumentation in ONGC??
what is the imbustion control loop
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
State some of balance principle’ advantages?
Why plc require in analog input 4-20amp & 0-10 volt?
What is the procedure of calibration of Load cell?
how u calibrate pneumatic n motorized c/v?
What is the difference between ff transmitter and non ff transmitter
How to calibrate level transmitter with use of HART?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
How many interlocks at turbine? Plz explain briefly
What is the difference between PLC and DDC?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
