Dear All, Pls let me know about ELR.... CBCT is using for
singnal purpose... How it works.. any body can explain
pls.......
- 4 Answers
- 13838 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.murugan kumar
CBCT is used for current leakage purpose via earth.If any
leakage current goes to any equipments (For example:Busduct)
it will be by pass that the leakage current to earth.So it
will act some relay.This is the CBCT purpose.This is not a
signal purpose this is protection purpose of any equipments.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to check avr of dg set of 125kva
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
Why AC current leads voltage in capacitor and how?
what could be the RMS value and average value of a 4 phase sine wave?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
how load of a turbo generator can be increased
Tell me all plants load factors i.e which plant operating on which load?
Sate maximum power transfer theorem?
Explain the advantages and disadvantages of hydropower plant?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
what percent do you derate your copper wire when you change from copper buss to copper wire
what is is the potential diffrence between two phase ?
