what is plc? Basic function of plc? application of plc in
industry? What is lader diagram ? What is the main advantage
to use plc in industry?
- 15 Answers
- 102060 Views
- Schlumberger, I also Faced
- E-Mail Answers
Answer Posted / ankit arora
ladder programming is a language . ladder language is a
combination of input contacts and output coils for make a
logic programm.
| Is This Answer Correct ? | 55 Yes | 8 No |
Post New Answer View All Answers
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Why boiler chimney area oxyden sensor fixing?
Please asked me How calculate DCS controller memory.
which type of zones used for boiler? & why ?
What is the use of gauge?
Explain PID, ON/OFF, Controls
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
What is the diffrence between digital signal processing and discrete signal processing?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
how u choose thermowell lenght n pnumatic C/v size?
