what should be the megger test report for 11KV cable when
meggered with 5KV megger , what is the resistance value we
should get
- 7 Answers
- 14804 Views
- I also Faced
- E-Mail Answers
Answer Posted / jesudoss
for land minimum >50 mega ohm, marine >100megaohm.its
minimum requirement . but this value can be vary depends
upon the surveyor like DNV,BV,ABS,LOYDS etc.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is the difference between alternator and generator?
difference between crane drive and line drive.
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
v/f drive basic princeple
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
What type of DC motor would you see for a lift?
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What is power factor why we should maintain the power factor unless what will happen
can u describe the method used for protection of transmission line.
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
What are the Full Forms of TVM, MTL, CVT ?
