Interested to Buy Any Domain ? << Click Here >> for more details...
Working principle of vibration sensor?, Type of vibration
sensor? , Can we use vertical instead of horizental or vice
versa?, if not Reasons?
- 2 Answers
- 11564 Views
- I also Faced
- E-Mail Answers
Answer Posted / muhammad nadeem
It works on electromechanical principle.Nadeem
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
What is Cavitation in a control valve?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Calibration procedure for water rotameters
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
what are the steps I have to deal with?
any body please send me the old question papers of ongc test.
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
What is first echo & echo window in radar type level transmitter?
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
give me all the details about the interview and which type of question being asked
