Answer Posted / aarti dahiya
A TRIAC is a three termnal bidirectional semiconductor
switching device which can control alternating current in a
load
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
Why is negative feedback invariably preferred in closed loop system?
What is meant by positive and negative feedback?
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how does it help for selection of a transformer.
What is BusBar integrity test and how it is conducted?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
