what is the meaning of potential free contact.
difference between dry and wet contact?
- 6 Answers
- 92928 Views
- GAIL, I also Faced
- E-Mail Answers
Answer Posted / sk
Potential free contacts (also called "dry contacts") are
simply contacts which are physically operated with the main
device, but not electrically connected to it. For example a
motor contactor often has auxiliary contacts that are
operated by the main coil and open and close at the same
time as the main contacts but are not used for control of
the motor starter. If they are connected to an outside
circuit to indicate the status of the starter without being
powered by the motor supply they would be considered
potential free contacts.
These type also called Signal-Contacts.
Read more:
http://wiki.answers.com/Q/What_is_potntial_and_potential_free_contact#ixzz1d6LFHY9N
| Is This Answer Correct ? | 33 Yes | 8 No |
Post New Answer View All Answers
how pressurize drum calibrated ?
What is the basic difference between Modbus and CAN Open Protocols
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
What are different types of orifice plates?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
where cascade loop use ?
Explain how thw analog to digital converter works with the circuit diagram
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
Speedtronic system .
What are different types of control valves?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
how u calibrate pneumatic n motorized c/v?
Positioner usage.
can we copy the software from a transmitter using hht(hart 275) ?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
