Interested to Buy Any Domain ? << Click Here >> for more details...
what is the advantage by using PID controller than P& PID?
- 1 Answers
- 5951 Views
- I also Faced
- E-Mail Answers
Answer Posted / bunny
By using a PID controller we can eliminate the offsets and
unwanted oscillations of the process variables we are
dealing with and will get the process variable value close
to the set point value.For that we need to tune the
controller properly and select proper values for P,I and D
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
Name different types of bourdon tubes.
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
what is the diffrence between pressure safety valve & pressure relief valve....pls
Which products are available in the Mass Systemswitch and System Manager AC range?
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
State some of balance principle’ advantages?
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
what is the imbustion control loop
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
