Induction type 1-p wattmeter reads …..
a) true value b) apparent value c)volt ampere value
Answer Posted / yashobanta rout
true value
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How digital input and digital output 's are working in dcs
What is zener diode? What is voltage regulator?
Calibration of controller (pneumatic)
what is RTV function in in process control?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
what is diffrance between FF & SMART, explain with difination
What is the use of each wire in three wire RTD
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
How process line mpm calculation is done?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
what is the electrical operation procedure for switching on 27.6MVA electric furnace.