what is the weight of concrete for 1 cum?
- 14 Answers
- 34965 Views
- L&T, Vellapally, I also Faced
- E-Mail Answers
Answer Posted / ilayaraja
2425
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Please tell me the quantity of cement, sand, flyash, foaming agent required for 1 cubic meter of cellular lightweight concrete blocks. also , is there any admixtures required for the CLC blocks production.
what is the proper procedure in conducting a california bearing ratio penetration test on soil on cbr machine?
What is meaning of tlc
what is the difference between tsp & tower
who to find building iron rod strenth
beam length 73 feet 4 inch,width 01 feet,height 50 inch so every beam load how much? and what quantity of M.S ROD? both side ony two column in middle no column.pls inform me that this is stable or not ? and how much risk of this beam?
for a column of size 400*230mm column reinforcement= 8-20x(cant write the symbol,i hope u guys undersstand,something like (fi) column stirups=8x@(4l) 230c/c 1)what does these mean 2)how to calculate quantity of steel for this column(ceiling height 11 ft)
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
about higyway engineering
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
howto calculate the quantities of material used in fly ash brick after finding the volume??
Explain the water bound macadam roag
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
Explain the term 'Gross unit rate' and identify the items that may be included in the gross unit rate.
How is improve my knowledge in construction industries....
