WHAT IS THE SPLICE LENGTH WHEN WELD IN REINFORCEMENT STEEL
- 8 Answers
- 11029 Views
- I also Faced
- E-Mail Answers
Answer Posted / at
no splice length is required as per
is.
direct welding is used of same
strengh or more than bar.
in mes as per ssr we used 100mm
min lenth for lap welding.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
i have a interlock pavement work.i need to compact about 2000 sq metres of sub base grade c of thickness 15 cm.what is the amount of water required for compaction ??
in one SQM plaster how much Cement and sand consumed in ratio 1:4
Describe Briefly The Various Methods Of Concrete Curing?
What is diversion tunnel in a dam?
the magnitude of the buoyant force can be determine by newtons law of viscosity archimidies principal principles of momemnt none
Explain what is Hybrid Foundation?
how calculate the bearing from two coordinates?
What are the RISKS during the project construction?
what is the service corridor?
WET BULB TEMPERATURE AND DRY BULB TEMPERATURE?
What sizes of stones chips are used for foundation, column and floor casting. Please answer in detail.
how do you calculate the length of "L" of main & distribution bar for reinforcing of raft footing
use ofr concrete as per grade ?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
What applicable rate of wct in bihar
