Why we use three phase world wide why not four phase or
five phase being used?
Answer Posted / reddy
we can use any number of phases for supply....but we maximum
use 3phase supply because.. as tht number of phases get
increase system complexity increases... so 3phase is
efficient among them....
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
What is meant by reset level of the relay?
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
why does rotor rotets?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
What is the formuala to calculate the rating of motor protection circuit breaker
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
where the lexical paramater will use in fron end?
If any cable burnt how can we identify it burnt by high current of high voltage?
What is reverse power relay?
what is per unit calculation?looking for simple and strong explanation thk u
how to check ac servo motor