out of DSBFC, DSBSC, SSBSC and VSB which is best for comm
purpose and why?
- 1 Answers
- 5773 Views
- I also Faced
- E-Mail Answers
Answer Posted / shiva vadla
vsb.why becoz at tx we send one sideband & carrier.here we
save more power.here we are sending carrier for demodulation
purpose only.at the rx end carrier selection is difficult, so
we are sending carrier.
| Is This Answer Correct ? | 2 Yes | 14 No |
Post New Answer View All Answers
What are the various logic gates?
What is the necessity of heat sink?
How are electrons in an atom visualized?
What are the main advantages of integrating type adcs?
1.Explain 3D radar. 2.Method of mobile signal jamming. 3.Frequency hopping spread spectrum. 4.How does op-amp works in common mode? 5.Which flip flop is known as universal flip flop and why?
In india What are the best institutes for telecom job oriented training,am b.tech e.c.e fresher?
hello sir, could u plz send me a sample placement paper for hpcl trainee engg exam..(electrical stream)...hoping to hear from u at the earliest
hii m persuing b-tech.i just pass 2nd year.pls tell me what are the ways to join BARC.
"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,
In a UPSR what is the limit on the number of nodes that form the ring?
Power bjt is a current controlled device. Why?
What is the need for load flow study?
objective questions & answers in c & c++ software languages
What type of questions are asked in Tetra pak onlinr test
What is the work of Bus cable, Power cable and Er cable in nokia flexi edge bts.
