What is the DIfferences between SMART transmitters and
PROFIBUS DP/PA Transmitters?
- 4 Answers
- 9465 Views
- I also Faced
- E-Mail Answers
Answer Posted / rathina
Basically trouble shooting point of view, multimeter if
enough to trouble shoot the SMART Transmitter. but Profibus
we need some kind of PLC loaded PC's
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is IEC code in cables & how to selecting cables?
What is the use of GMV in turbine?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
How is automatic reference junction compensation carried out in temperature recorders?
What is super thermocoupal?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is instrument philosophy
what is loop1 and loop2 in MTS LT?
Why are the uses 24vdc in industries
Why boiler chimney area oxyden sensor fixing?
What is the purpose of LO Overhead tank in turbines.
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
Can anyone send most commonly asked interview question in Oil & Gas industry
Explain PID controller tuning & any one method used for it.
What is difference between radial vibration and axial vibration explain in detail .
