Answer Posted / dharamveer yadav

as we know in industry there is both inductive and
capacitive load for better efficiency and life of equipment
we require to maintain power factor at unity otherwise
there is leading or lagging power fator and which is not
desire for better efficiency and if your power factor is
goes down to .8 then you have to pay charge for that

placement paper samples of mspl company

1946

---

what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator

2059

---

what is the string efficiency

5256

---

how is capacitor bank look like

2411

---

If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??

2011

---

how we findout a ignater is faulty or not?

2109

---

Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.

2161

---

Define conversion efficiency of a power amplifier.

1246

---

what is the preventive maintence for ht panels and busbars and vcb abd acb's.

2384

---

What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?

6305

---

how can we calculate the ratio of caustic soda and water in lrs.

5848

---

there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit

1937

---

why we use sinosidal voltage / current instead of others in system?

2218

---

if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm

2259

---

if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.

1992

---