why there is spacing between two rails in railway?
- 3 Answers
- 5032 Views
- DS Group, RRB, I also Faced
- E-Mail Answers
Answer Posted / sathish
weight equalation
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Difference of induction motor & servo motor ??
What is inrush current? how can calculateit? what is the affect of it?
Zone of protection and tripping scheme of arc protection relay.
What is the minimum underground tank size capacity considered for firefighting purpose?
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
Define closed loop control system.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how does directional relay work incase of ac ?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
What is s-domain and its significance?
can anyone give an idea about dia calculation in cold rolling mill
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
