Why indian power system in 11kv,22kv,33kv,66kv,110kv,220kv ?
2) Why ups required dedicated earth?
- 8 Answers
- 17655 Views
- Energia, L&T, Sail, I also Faced
- E-Mail Answers
Answer Posted / sandeep ojha
because form factor is 1.11and emf equation is 4.44 kφtf and frequency is 50Hz so value is comes out in multiple of 1.11 & 50
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
What is block diagram?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
What is kirchoff ’s current law (kcl)?
Explain how you intend to work under pressure to meet up with deadline target?
What is 11 N1 and 12 N2 in single phase Transformer ?
What is mean by Sensitive Earth fault & what are the effects
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Draw the circuit of clapp oscillator?
what are the difference between PLC and embedded
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
What are the different power system losses and how can it be eliminated?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
What is the formula to calculate the rating of power cable for three phase current.
