why cant we use mV instead of mA?
- 12 Answers
- 20268 Views
- ABB, Power Grid, Qatar Gas, USW, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / mahesh soni
Distance is the main concideration, as distance increases
voltage drop will be increased where current remains same
due to ohms law there is
I=V/R SO CURRENT VWILL SAME any time or no lossed by
wire resistance so v can lay cables long root laying in
plant& all instruments draw curren not voltage
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
How to convert Differential pressure to flow in TPH
Question on maha cement
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Difference between ultra sonic flow meter
How to Calibrate Interface Level Troll in field
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
what is interface level and how it is calibrate?
Introduce yourself which is not present in your biodata?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Conversions
Draw symbols of the following :
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
Who to difference between analog in & analog out in dcs?
Why MUX JB's are using only Temperature Element in Fundation field bus?
