Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tsegahailu1336
it is the proportioning of the constituent of a mortar mixture.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
pls tell me about method of cutting length of ties column
1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.
how to absorb to site basic corrections? which are the important correction?
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
What is the snap size in civil and how can we create it?
What is the likely strength of a 1:2:4 concrete mix?
how much cement is consumed by a stone masonry wall 17.7m long,0.55m wide and 1m high
what are the grades of concrete?where and or what purpose a particular grade is used in a particular structure?
What are the advantages of cad software?
1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.
How many times we can use Fresh bentonite ford wall execution? Would like to know the clear concept of recycling. After flushing can we use it for another time time for flushing? Or we have to use it for for excavation only?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
Wats the formula of eccentric footing and how was calculated from concrete qty
how to calculate labour strength for work for RCC,brickwork,blockwork,in &out plaster,flooring,dado,door frame & shutter,painting etc for constructing highrise building?
Why you are leaving present job?
