what should be the attitude while answering an interviewer?
- 2 Answers
- 4508 Views
- I also Faced
- E-Mail Answers
Answer Posted / mukesh
give the clear answer to the interviewer.if u dont know
tell them directly.dont try to give the unknown answer
because it can make disappointment to t6he interviewer.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
In turbine what does term CDP, NI, NH, HSSOC means.
How to work temperature gauge?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
What is the difference bitween control net scaner and device net scaner
what is the reset offset and control system in instrumentation
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
why I need valve guard and whats different between guard and positioner ??
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
what is span value and zero ? and how set ?
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
