Interested to Buy Any Domain ? << Click Here >> for more details...
What is the tolerence limit between neutral and earth in
230 V AC System?
- 7 Answers
- 11244 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / dolly prasad
2V IS THE TOLERANCE LIMIT BETWEEN NEUTRAL AND EARTH.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
How do you compute voltage drop and cable size over distance?
what is die electric strnth of transformer ?
How does an oscillator differ from an amplifier?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
why moisture formation found in XLPE Armoured cable outer sheath
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
which types of relay used in acb and vcb?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What OPGW is better than Microwave or PLCC???
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
