why the earth terminal in three pin top is longer than rest
of the two terminal and of bigger size?
- 6 Answers
- 10442 Views
- BARC, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / bhatt
As we know earth is connected to the body of
equiment/machine hence if earth terminal is longer then
earth will be connected to body of equipment/machine first
thereafter phase and neutral. It is bigger size because it
must not go in phase & neutral terminal by any mistake so
as to avoid any direct contact of body of machine with
phase/neutral.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
list of tests to be carried out at manufacturers end while purchasing a step up transformer of 11kv to 66kv ,2MVa Capacity.
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
what is apparent poewr, reactive power, & active power?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What is the source of dependent source ?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Mention the disadvantages of low power factor?
What is the difference between AC and DC injection methods for rotor earth fault protection
Why neutral point is consider as zero potential?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
Why strting torqe high in inducation motor?
Is electro plating what type of load whether resistive, inductive or capacitive loads
