What happen when ct secondary are open circuited? why same
thing is not happen in ordinary transformer?
- 3 Answers
- 6739 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / bhatt
If secondary of CT is opened and as we know that primary
always flow the current and by transformaton action
secondary must flow the current but in our case secondary
is opened hence Extra high voltage is induced in terminals
of secondary which can be fatal.
In case of ordinary transformer if secondary is open
primary flows only no load current hence secondary voltage
is only rated secondary votage which is not as danger as in
the case of CT.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is rotating magnetic field?Discuss elaborately.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is the formula of frequency ?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
How is the gain affected by the introduction of feedback in a control system.
how we can calculate the efficiency of a diesel generator ?
can i connect wavetrap in 2 different phase in EHV line?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
Why are the laminations insulated from each other?
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
how is the magnetic current test is different in delta-star and delta delta transformer.
what is the difference between changer, converter and transformer?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
how to failure indution motor insulation & how to improve heat in motor insulation
