Answer Posted / vikram singh
TPN means tripple pole + neutral....in case of MCB only, TPN
is call 4 Pole also....but in case of SDFU, MCCB, ACB etc
TPN means 3P+N, which means that 3Pole SDFU, MCCB ACB etc is
taken and nuetral busbar runs as 4th pole with it
Is This Answer Correct ? | 20 Yes | 6 No |
Post New Answer View All Answers
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
What is the height of DA, DAL, DB, DC & DDE tower?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
How does zener phenomenon differ from avalanche breakdown?
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
how can maintaince the acb contactor moveing and fixing kit
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
What is difference between insulating medium and fault current interruption medium in a switching device.
What is the effect of positive feedback on the stability of the systems?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
why the active power flow of some line is increased when the active power of out is cut ?
what material is the electrical housing wire made of? is there any difference for the telephone lines?