if 2500 KVA TRANSFORMER CAPACITY.33KV INCOMING HOW ARE
AMPEAR PRIMERY SAID
- 3 Answers
- 5447 Views
- Cipla, I also Faced
- E-Mail Answers
Answer Posted / patilharshal88
PLZ SEND ANS EARLY
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
explain safety measures in alternator?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
what is the relationship between phase & neutral
How to connect the chemical earthing and complete process tell me plz
what is the max. acceptable leakage current in 33kv bus bar
How is the percentage impedence of a transformer fixed at design stage???
how to check avr of dg set of 125kva
is there any current and voltage drop on liquid resistance starter water/soda tank ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Explain about Leakage Test.
What is pd controller?
