depletion layer will form beforre biase or after bias ?
- 2 Answers
- 2827 Views
- I also Faced
- E-Mail Answers
Answer Posted / sagar upadhyay
It's present every time. Just its width varies with the bias
applied. With forward bias, width reduces & vice versa.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is value of Jin transformer
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
Zone of protection and tripping scheme of arc protection relay.
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
How servo stabilizer works.
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
what is inverter and converter
how are reversing the direction of rotation of dc motor
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
diff b/w normal grounding and resistance grounding
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
