What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
Answer Posted / m. saqib ali nafees
AN EDDY-current probe works on the basic magnetic principles
(Faraday's law and lenz's law) when an electrically
conductive material comes close to the probe we know that
alternating current pass though coil this alternating
current produce EMF in electrically conductive material
(observed surface) by Faraday's law. This produced EMF
oppose its source by lenz's law. ( when the current through
a coil changes and an induced voltages is created as a
result of the magnetic field, the induced voltages in such a
direction that its magnetic effect will oppose the Change
that produce it.) The output voltage vary according to gap
between probe and observed surface by these two laws.
| Is This Answer Correct ? | 22 Yes | 3 No |
Post New Answer View All Answers
Why trim span ? How?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
what is interface level and how it is calibrate?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
Can I calibrate the Electromagnetic Flow Meter on line and How.
How to calibrate Toxic gas detector?
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
Where is wet leg is used?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
the output of the common trasmitter protocol in qatar gas are the following
Differentiate between ultrasonic flowmeter and radar type flow meter
what is scale factor of proximitor & unit of the vibration.
What is the constant voltage unit?