i want interview questions about PROCESS CONTROL
INSTRUMENTATION ,
SENSORS AND TRANSDUCERS IF ANY BADY KNOW ABOUT THAT PLEASE
SEND TO MY MAIL karumudi1003@gmail.com
- 8 Answers
- 23147 Views
- Honeywell, Reliance, I also Faced
- E-Mail Answers
Answer Posted / kobena
my email is kobenaw@gmail.com
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is loop1 and loop2 in MTS LT?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
what is the input to be given in digital flow meter during the the calibration time?
How to Calibrate Level Switch in field
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
what effects a surging can produce in the compressor
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
How to Calibrate Flow Switch in field
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
How to find out the current of two motors having same power consumption but different RPM?
