Answer Posted / naresh
25kv dc
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
why transformer ratings in kva? & DG ratings in kva? & Motor ratings in kw/HP?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
How is the percentage impedence of a transformer fixed at design stage???
What do you mean by a phase angel of instrument transformer?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
Inverter. converter. Ups.MCB.solar.alternators. motors.
how to increase senstivity of ct
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is meant by bus bar protection?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Explain about retrofitting of machine tool.
