In a star-star connected h.t transformer why we use NGR on
the secondary (l.t)side.
- 3 Answers
- 6778 Views
- Star, TATA, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
To reduce the earth fault current in the secondary and for
primary it is of no use .
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
How to Preparation of online test
Is there any specialised book to refer about fault level calculation both in MV and LV side??
Define relative stability.
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
explain comutator action in detail.thanks
what is negative d.c. voltage, why this voltage is used in base transciever station.
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
Why is better to have a minimum ceiling voltage of 250% than 160%?
how r charge carriers produced
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
