Interested to Buy Any Domain ? << Click Here >> for more details...
Why underground cables are used to connect transformers?In
addition how are they again connected to lines after step up
or step down?
- 1 Answers
- 4068 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
UG cables have to be used when indoor breakers(11KV) are
employed.They are connected to the outgoing lines at the
outdoor structure after step-down.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
why the rotor current becomes in steady state during high slip region? please verify with equations.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
How Can you do Maintenance of ACB of 2000Amperes
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
The moisture in air will condense at
how we can calculate power factor in single phase & three phase ?thank u
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
State the frequency for rc phase shift oscillator?
Difference of induction motor & servo motor ??
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
When will you multiply and devide with derating factors to the actual value while sizing the cable?
