what are all the preventive maintainance carried out in DG?
Answer Posted / chandrasekarapandian
A check
1. replace Air filter
B check
1. Replace Oil filter, Loop filter , Fuel filter
2. Replace new oil
C check
Check for exhaust line(smoke line)
All these checks depends upon DG capacity & running
condition
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
What is the necessary and sufficient condition for stability.
How earthing/grounding done in aeroplanes and ships.
In Power cable specification what is U0/U and Um.
why current flow to the opposite direction of flow of electrons???????????
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
Why hydropower stations are preferred solution for meeting peak loads in grids?
Differnce between negative Pahse SequenceFunction and unbalance Function?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
An automatic water heater is an example of which type of control system?
What is time invariant system?
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
When will you multiply and devide with derating factors to the actual value while sizing the cable?